|
| |
Alarmsense Panel
|
The Alarmsense Fire panel has been designed to work with the
2 wire Apollo Alarmsense
Detectors, Sounders and
Call Points 2 Wire Works by using
different voltage bands for quiescent and alarm states, which allows
detectors, manual call-points, input or output modules and sounders or
beacons to be connected to the same pair of wires, thus making installation
quicker, less expensive and more flexible |
 | Designed to work with Apollo Alarmsense
2 wire range of Detectors,
Sounders
and Call Points. |
| Compliant with EN54 |
| 3 Auxiliries: 1 Fault, 1 Alarm relay - Reset on silence, 1 Alarm Relay -
Reset on reset |
| 1.5 Amp Integral power supply |
| Battery capacity 7Ah |
| Repeater outputs |
| Reset, silence, evacuate inputs |
| One man test facility |
| Ability to distinguish between call point and detector operation |
| Zonal sounding capabilities |
| Isolation of detectors only capability |
| 2 Stage Alarms
This panel has been designed to work with the Apollo ‘2 wire’ Alarmsense
range of detectors, call points and sounders. The panel consists of two
printed circuit boards; one contains the zones and sounders and the other
the power supply. A complete set of diagnostic indicators is provided to
assist in locating system faults such as zone, sounder and power faults. The
front panel controls not only control the sounders and reset the detectors
but also controls the isolation feature. Various functions can be isolated
for test purposes such as complete zones, detectors only, sounders, and
auxiliaries. A one-man test facility can be accessed enabling the smoke
detectors to be automatically reset after activation. A number of auxiliary
relays are fitted as standard to enable fire panels to be interlinked, door
magnets to be operated and communications to be triggered. Internal switches
are provided to provide various functions, such as Zonal sounding, delay
sounding of detectors, pulsing sounders, detector isolation facilities, and
zone 1 non-latching.
A complete set of connection is available to drive repeaters that can be
surface of flush, and with or without controls. A glass door version is also
available along with a flush kit.
4- 12 Zone - 350mm high x 450mm wide x 110mm deep
2- 4 Zone - 300mm high x 350mm wide x 85mm deep
Metal cabinet with lift off front door with knockout at top and bottom.
Fitted with lock and enable key.
Power supply 240v 5OHz input. 12 zone current limited to 2amps for a maximum
of 2 x 7AH batteries for the 2 – 4 zone panels, and 12Ah Batteries for the 4
– 12 zone panels. |
|
