|
| |
Senza SaveWire Panel
 |
The FireSense SaveWire Panels are 2 wire panels that have
been designed to work with Apollo Savwire detector bases, Hochiki PA4, and
PA5 type bases. The zone voltage reverses in the alarm condition to operate
sounders on these zones. The panels are available in 2, 4. 6. 8 and 12 zone
models As the detectors, call-points and sounders are all connected on the
same pair of wires, the installation is quicker, less expensive, and more
flexible, especially when adding additional items |
 | Meets BS5339 part 4 and EN54. |
| Integral detector removal monitoring indicated zonally using special
Savwire detector bases. |
| Suits Apollo and Hochiki detectors. |
| 3 auxiliaries: I fault, 1 Alarm relay - Reset on silence, 1 Alarm Relay
- Reset on reset |
| 1.5 amp integral power supply. |
| Suitable for up to 7AH batteries. |
| Low voltage battery protection. |
| Repeater outputs. |
| Reset, silence, evacuate inputs. |
| Precinct/class change input. |
| One man test facility. |
| Isolation of zones, relay, sounders and inputs. |
| Suitable to drive most types of sounders, beacons, and polarized relays.
These panels are designed to comply with BS5839 and EN 54. The panel
consists of two printed circuit boards; one contains the zones and sounders
and the other the power supply. The power supply is rated at 2amps, monitors
battery voltage and has a built-in low voltage battery protect relay to
prevent deep discharge. The main board has connections for zones and remote
evacuate or class changes, together with three auxiliaries, one for fault,
one for alarm - reset on silence, one for alarm - reset on reset. It also
has a full set or repeater connections, including remote evacuate, silence
and reset. Each zone is monitored for open circuit, short circuit detector
head removal using no more than a resistor at end of line. Detectors must
have special detector bases and will drive any sounder, beacon, or polarized
relay on the zone. Each zone is separately fused for sounder operation. As
well as displaying all faults on the front of the panel it is also possible
to isolate zones individually, sounders, auxiliaries and remote input, and
also to perform one man test operation, all from the front controls. The
panel is also provided with a number of internal switching features to
enable, for example, diode only call points, zone 1 non latching facilities,
delayed sounders, and pulsing sounders.
2-12 Zone - 300mm high x 350mm wide x 85mm deep
1-2 Zone - 260mm high x 240mm wide x 65mm deep
Metal cabinet with lift off front door with knockout at top and bottom.
Fitted with lock and enable key.
Power supply 240v 5OHz input. 12 zone current limited to 2amps for a maximum
of 2 x 7AH batteries. |
|
